Replicant

h1. Nexus S (I902x) Bootloader

The Nexus S (I902x) comes with a bootrom and a set of two proprietary bootloaders. The bootrom: internal ROM (iROM) is stored read-only on the S5PC110 SoC chip. It loads the first bootloader: Samsung Primitive Bootloader (PBL), which loads the second bootloader: Samsung Secondary Bootloader (SBL). These bootloaders are proprietary software.

More information on the booting sequence is available on the S5PC110 User Manual, section 2 (system), part 6 (booting sequence).

h2. Boot device priority

The S5PC110 bootrom (iROM) allows booting from various devices such as NAND, MMC, eMMC, UART and USB. The boot device priority is selected using the Operating Mode (OM) pins. Boolean values for each pin depend on the voltage applied to the pin: a positive voltage represents a logical 1 while ground represents a logical 0.

h3. Board resistors

OM pins are set to boolean values using pull-up (logical 1) and pull-down (logical 0) resistors. The Nexus S (I902x) schematics show all the possible resistors connected to the pins.

According to the Nexus S (I902x) Schematics:

!crespo_om_schematics.jpg!

Only a few are actually populated on the board:

!{width: 50%}crespo_om_board.jpg!

According to the Nexus S (I902x) Service Manual:

!{width: 50%}crespo_om_components.jpg!

Resistors highlighted in green are not populated on the board. Hence, the actual layout is the following:

| |_. XOM5 |_. XOM4 |_. XOM3 |_. XOM2 |_. XOM1 |_. XOM0 |

| Pull-up resistor | N/A | N/A | R429 | N/A | N/A | R435 |

| Pull-down resistor | R448 | R447 | N/A | R445 | R444 | N/A |

| Boolean value | 0 | 0 | 1 | 0 | 0 | 1 |

According to the S5PC110 User Manual, section 2 (system), part 6.2.4 (OM pin configuration), table 6-3, this indicates OnenandMux as first boot device.

h2. Secure boot

According to the S5PC110 User Manual, section 2 (system), part 6 (booting sequence), the bootrom (iROM) found on the S5PC110 SoC implements secure boot, which is enabled depending on the value of an e-fuse:

<pre>

If you select secure booting, iROM code and first boot loader provide integrity checking function (that is it uses

public key algorithm) to verify loaded image. There are 160 e-fuse bits of secure boot key, and they are used to

authenticate loaded public key before the iROM’s integrity check.

</pre>

This implies that in secure boot mode, the bootrom (iROM) will check the signature of the first bootloader and refuse to boot if the signature doesn't match the secure boot key. More information on this topic is available on the S5PC110 User Manual, section 2 (system), part 6.2.2 (booting sequence example), figure 6-2.

On the Nexus S (I902x), secure boot mode appears to be enabled: changing a single byte on the first bootloader ended up in the system refusing to boot. In addition, a few messages from the bootloaders output suggest that such signature checks are enforced: @IROM e-fused - Secure Boot Version@.

The first bootloader (PBL) appears to be implementing and enforcing a similar secure boot mechanism. However, there is no signature check enforced regarding the Linux kernel.

Since signature checks are enforced by the bootrom and provided that there is apparently no easy way of replacing the public key the signatures are checked against, running free software bootloaders on the Nexus S (I902x) seems impossible.

It is however possible to run a free software bootloader (U-Boot) as second bootloader using a version of the first bootloader (PBL) that does not enforce the signature check.

h2. Stock bootloaders output

<pre>

-----------------------------------------------------------

   Samsung Primitive Bootloader (PBL) v3.0

   Copyright (C) Samsung Electronics Co., Ltd. 2006-2010

-----------------------------------------------------------

Muxed [[OneNAND]] 512MB (0x50) Sync

Scanning Bad Block .......

Bad Block 77 (5)

Bad Block 295 (5)

Bad Block 1232 (5)

Bad Block 1646 (5)

Bad Block 1831 (5)

Bad Block 2047 (0)

SBL loadding success

Set cpu clk. from 400MHz to 800MHz.

OM=0x9, device=OnenandMux(Audi)

IROM e-fused - Secure Boot Version.

-----------------------------------------------------------

   Samsung Secondary Bootloader (SBL) v3.0

   Copyright (C) Samsung Electronics Co., Ltd. 2006-2010

   Board Name: HERRING REV 52

   Build On: Jan 20 2011 17:19:41

-----------------------------------------------------------

MMC SEM16G 15188 MB

Re_partition: magic code(0x0)

Muxed [[OneNAND]] 512MB (0x50) Sync

Scanning Bad Block .......

Bad Block 77 (5)

Bad Block 295 (5)

Bad Block 1232 (5)

Bad Block 1646 (5)

Bad Block 1831 (5)

Bad Block 2047 (0)

Partitions loading success

Read image(PARAM) from flash .......

Done

init_fuel_gauge: vcell = 4083mV, soc = 94

PMIC_IRQ1    = 0xc0 

PMIC_IRQ2    = 0x0 

PMIC_IRQ3    = 0x0 

PMIC_IRQ4    = 0x0 

PMIC_STATUS1 = 0x0 

PMIC_STATUS2 = 0x0 

PMIC_STATUS3 = 0x0 

PMIC_STATUS4 = 0x0 

PMIC_STATUS5 = 0x0 

PMIC_SMPL    = 0x0 

Key scan = 0x0

message.command = 

message.status = 

message.recovery = 

BOOT_MODE_NORMAL (SW_RST(0x00000004), INFORM(0x000000ee))

LCD ID = 0x0060a953

Done

Kernel(boot.img) read success from partition no.5

Setting param.serialnr = 0x3733bab6 0x6de200ec

Setting param.board_rev = 0x34

Setting param.cmdline = console=ttyFIQ0 no_console_suspend androidboot.serialno=3733BAB66DE200EC androidboot.bootloader=I9020XXKA3 androidboot.baseband=I9020XXKB3 androidboot.info=0x4,0xee,1 androidboot.carrier=EUR gain_code=3 s3cfb.bootloaderfb=0x34a00000 mach-herring.lcd_type=0x00000000 oem_state=unlocked 

Setting param.initrd_start = 0x31000000, param.initrd_size = 0x23265

Starting kernel at 0x30008000...

Uncompressing Linux... done, booting the kernel.

</pre>

h2. References

* S5PC110 User Manual: http://dl.project-voodoo.org/documentation/S5PC110_EVT1_UM10.pdf

* Nexus S (I902x) Service Manual and Schematics: http://mobilcoms.ru/load/1-1-0-4499

*These documents are the propriety of Samsung Electronics and are not hosted by the Replicant project. However, some excerpts from these documents are provided, for the purpose of providing technical evidence of the facts that are mentioned in this page. We believe that this particular use of the copyrighted work is fair use.*

* Create your own I9000/S8500 (& all S5PC110 based devices) bootloader&ultimate unbrick (XDA): http://forum.xda-developers.com/showthread.php?t=1233273 

* Hummingbird Interceptor BootLoader: https://code.google.com/p/hummingbird-hibl/

* U-Boot second bootloader port: https://github.com/hackqiang/crespo-bootloader

* Bootrom (iROM) dump and disassembly: https://github.com/OSLL/boots/tree/master/S5PC110